Remover - a specially selected blend of solvents and (or) bases with a thickener, prevents rapid drying of the composition and formation of stains on vertical surfaces. Wash stand expensive, and work with them takes a lot of time. To broaden your perception, visit search. More productive is a thermal method, involving softening paint under high temperature, which is provided with hot air generated by a special dryer. The paint is softened on small plots and removed with a scraper. Unfortunately, this dryer is quite expensive, as is classified as a professional building instrument (hair styling is absolutely not suitable, although it does not stand on the principle of action). Note that the recovery of skirting with complete removal of old paint coatings and subsequent elimination of defects using putty, is likely to be economically viable.

Prepare surfaces for finishing After the removal of old coatings to eliminate the defects of the walls and ceiling. To facilitate the penetration repair material (putty) in the crack they need to broaden (expand), the damaged areas cleared of weakly holding on fragments, exfoliated ('bubnyaschie') sections of the plaster layer is completely removed. Prepared thus the surface of a mandatory processed for primer composition of hygroscopic (moisture absorbing) bases, such as 'Tiffengrund' (TIGI Knauf). Primers - aqueous solutions of polymers containing long polymer chains that can penetrate deep into the porous structure of concrete or plaster and be secured within it, greatly strengthened by the surface layer of the base and eliminating dust, which, in turn, provides maximum adhesion to the mortar material base. After the primer has dried and deep gouges where plaster layer fell off, sealed cement-lime plaster solution. In extreme cases (to accelerate the process) you can use the alabaster or plaster solution to the gypsum-based type 'Rotband' (TIGI Knauf). Typically, this operation is performed using a rectangular trowels, stainless steel - tools most comfortable and versatile.