The depth of the pit depends on the length of the column and fourth part. To fence not looked, all the wells should be of equal depth. 3. Treat lower ends supporting pillars of wood composition that prevents the process of rotting wood (creosote or bitumen). 4.

Set poles vertically in the holes and secure them with struts. Check the verticality of the poles and then to their the upper sections were located on one level. 5. Natyatnite on the top edge of pillars twine, which can help control the horizontal position of the establishment of panels. 6. fabricate from shtaketin prozhilin and cross bar.

For This first required number zagotovte shtaketin and make them, if necessary, cut a decorative ... then nail the two cross each run prozhilinam shtaketiny. Shtaketiny fixed at a distance of 20 cm from the upper and lower sections. In this first shtaketina at the beginning of each panel is not nailed. This will be done later. The distance between the panel shtaketinami depends on the design of the fence, but it should be noted that what is less is more boards need to make the fence. 7. attach the panel to the supporting poles west ends prozhilin. To facilitate the work can be put under the bottom panel of the bar, which, together with twine, stretched over supporting poles may control the horizontal mounting. 8. When all the panels will be installed at the beginning of each of them arrived the first shtaketinu. 9. enter into the pits under the supporting pillars of the concrete mix. To do this, first a good wet earth, that it does not absorb water from a concrete solution. After that, fill the hole with concrete and tamp it and. 10. Make a wicket in the same way as you build the panel. 11. On the one hand gate to cross prozhilinam stick at with screws iron hinges. just attach the loops to the respective supporting columns. Holes for screws are drilled in advance. 12. try a gate in place. check the evenness of its provisions, and only then attach it to the supporting columns. 13. fasten the latch.